Using the Playback Features
Time Search
The VCR will search forward or reverse the amount of time you select from the
location you are on the tape.
TIME SEARCH
Enter search time
0:30
Press FWD or REW
Press SEARCH to exit
Zero Search
The zero search feature allows you to quickly return to a counter reading of 0:00:00 at
any spot on the tape. This is convenient when you want to watch a segment of the tape
several times.
ZERO SEARCH
Current tape counter is
2:17:25
Press REW to go to 0:00
Press SEARCH tO exit
ZERO SEARCH
Current tape counter is
-2:17:25
Press FWD to go to 0:00
Press SEARCH tO exit
1. Insert the prerecorded tape, and press STOP.
2. Press SEARCH on the remote twice to display the
TIME SEARCH menu on the TV screen.
3. Press number buttons to enter the hour(s) and
minute(s) of the time counter reading you want the
VCR to search.
Press CLEAR to correct an entry.
4. Press FF on remote or turn the shuttle ring
clockwise toward FWD on the VCR to search
forward.
Press REW on remote or turn the shuttle ring
counterclockwise toward REW on the VCR to
search in reverse.
5. Press STOP to stop time searching.
1. Insert the prerecorded tape, and press STOP.
2. Press DISPLAY twice to display only the time
counter on the TV screen.
3. Locate the point on the tape that you want to
return to quickly.
4. Press CLEAR to reset the time counter to 0:00:00.
5. You can continue to play the tape or perform other
functions. When you are finished, press STOP.
6. Press SEARCH three times to display the ZERO
SEARCH menu. The current tape counter is
displayed.
7. Press REW on the remote or turn the shuttle ring
counterclockwise toward REW on the VCR to return
to 0:00:00. The time counter is displayed in the
upper right corner of the TV screen during search.
If the time counters reading has a minus (– ) in front
of it, press FF on the remote or turn the shuttle ring
clockwise toward FWD to return to a reading of
0:00:00.
To Next Page
Loading...
Need help?
General
