Rheem IKONIC RTGH-SR11i User Manual

IKONIC Tankless Water Heater Service Manual
26
USER INTERFACE AND OPTIONS
RECIRCULATION - ON DEMAND
MODE
1. Press the “SETTINGS” button.
2. Press the “▼” or “▲” button until “Tankless Cong”
is displayed, and press the “ENTER” If incorrect set-
ting is entered at any steps, press the “BACK” button
to return to the Home screen. Redo from step 1.
3. Press the “▼” or “▲” button until “Recirc. Pump
Modes” is displayed, and press “ENTER” to conrm.
4. The Factory setting is “None”. Press the “▼” or “▲”
button until “On Demand” is displayed, and press
“ENTER” to conrm. To exit this setting, press “BACK”
button until the Home screen is displayed.
ON DEMAND RECIRCULATION
OPERATION
One of the following accessories are needed to use the
On Demand recirculation activation.
When set to "On Demand" mode, the recirculation pump
is ON for 5 minutes when the signal from the Motion Sen-
sor or Wired Push Button is received, or until the return
water temperature reaches approximately 15°F below
the setting temperature.
For information about On Demand accessories, refer to
the last page of this service manual for the telephone
number to speak to a Customer Service Representative.
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Mode
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Mode
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Mode
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
On Demand
RHEEM PART
NUMBER
DESCRIPTION
SP20862 Motion Sensor Kit
SP20863 Wired Push Button

Rheem IKONIC RTGH-SR11i Specifications

General

Brand	Rheem
Model	IKONIC RTGH-SR11i
Category	Water Heater
Language	English