System Switch 00
No FUNCTION COMMENTS
2
Technical data printout on
TCR (Journal)
0: Disabled
1: Enabled
1: The following data are listed on the TCR for each
analog G3 communication.
e.g. V29 96 01 03 00 02
First number: Final modem type used
Second number: Final modem rate (for example, 96
means 9,600 bps)
Third and fourth numbers: Line quality data. Either a
measure of the error rate or the rx level is printed,
depending on the bit 3 setting below. (An M on the
report indicates that it is error rate, and an L indicates
Rx level.) The left hand figure is the low byte and the
right hand figure is the high byte. If it is a measure of
the error rate; a larger number means more errors.
Fifth number (rx mode only): Total number of error
lines that occurred during non-ECM reception.
Sixth number (rx mode only): Total number of burst
error lines that occurred during non-ECM reception.
The fifth and sixth numbers are fixed at 00 for
transmission records and ECM reception records.
3
Line quality data output
method
0: Measure of error rate
(during image data
transmission only)
1: Rx level
This bit determines the data type to be printed on the
TCR (Journal) when technical data printout is enabled
by bit 2 above.
4
Line error marks
0: Disabled
1: Enabled
If this bit is 1, a mark will be printed on the left edge of
the page at any place where a line error occured in the
data. Such errors are caused by a noisy line, for
example.
5
Communication parameter
display
0: Disabled
1: Enabled
This is a fault-finding aid. The LCD shows the key
parameters (see the next page). This is normally
disabled because it cancels the CSI display for the
user.
Be sure to reset this bit to 0 after testing.
6
Protocol dump list output
after each communication
0: Off 1: On
This is only used for communication troubleshooting. It
shows the content of the transmitted facsimile protocol
signals. Always reset this bit to 0 after finishing testing.
7
Not used Do not change the settings.
August 7th, 1995 SERVICE TABLES AND PROCEDURES
BIT SWITCHES
4-13
To Next Page
Loading...
Need help?
General
