4.3. NCU PARAMETERS
The following tables give the RAM addresses and units of calculation of the
parameters that the machine uses for ringing signal detection and automatic
dialing. The factory settings for each country are also given. Most of these
must be changed by RAM read/write (Function 06), but some can be
changed using NCU Parameter programming (Function 08); if Function 08
can be used, this will be indicated in the Remarks column. The RAM is pro-
grammed in hex code unless (BCD) is included in the Unit column.
The addresses in brackets are used for BR1.
Address Function Unit Remarks
807F00
(006700 )
Country code for NCU parameters
Use the Hex value to program the
country code directly into this address, or
use the decimal value to program it
using Function 08 (parameter CC).
Country Decimal Hex
France 00 00
Germany 01 01
UK 02 02
Italy 03 03
Austria 04 04
Belgium 05 05
Denmark 06 06
Finland 07 07
Ireland 08 08
Norway 09 09
Sweden 10 0A
Switzerland 11 0B
Portugal 12 0C
Holland 13 0D
Spain 14 0E
Israel 15 0F
USA 17 11
Asia 18 12
Hong Kong 20 14
South Africa 21 15
Australia 22 16
New Zealand 23 17
Singapore 24 18
Malaysia 25 19
China 26 1A
August 7th, 1995 SERVICE TABLES AND PROCEDURES
NCU PARAMETERS
4-33
To Next Page
Need help?
General
