Maintaining Your Machine
If the exposure glass, scanning glass, or ADF is dirty, copy clarity may be reduced. Clean these parts if
they are dirty.
• Do
not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances get
inside the machine or melt plastic parts, a failure might occur.
• Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
How to maintain
Cleaning the machine: Wipe the machine with a soft, dry cloth. If this does not remove the dirt, wipe
the machine with a damp and tightly wrung cloth. If a damp cloth still does not remove the dirt, try
using a mild detergent. Wipe the machine with a dry cloth to remove the moisture, after using a damp
cloth.
Cleaning the Exposure Glass
This section describes how to clean the exposure glass and the scanning glass.
1. Wipe the exposure glass and the scanning glass.
1. Scanning glass
2.
Exposure glass
Cleaning the ADF
This section describes how to clean the ADF.
Maintaining Your Machine
99
To Next Page
Loading...
Need help?
General