Changing Modes
This section explains how to change modes.
The following illustration shows screens that appear when the fax and printer/scanner unit are installed.
• You cannot switch modes in any of the following situations:
•
When scanning a fax message for transmission
• During immediate transmission
• When accessing User Tools / Counter
• During On-hook dialing for fax transmission
• While scanning an original
• The copy display is set as the default screen when the machine is turned on. You can change this
default setting under Function Priority. See “System Settings”, Network and System Settings Guide
.
System Reset
This section explains System Reset.
After
finishing a job, the machine waits a specified length of time and then restores its settings to the default
values specified under Function Priority. This function is called “System Reset”. For the procedure for
specifying default settings under Function Priority, see “System Settings”, Network and System Settings
Guide
.
2. Getting Started
50
To Next Page
Loading...
Need help?
General