Ricoh MP W6700 User Manual

DNB111
• After the original has been delivered, instead of leaving it, hold its end in your hand and move it
away before the next original is delivered.
• The multi stacker can be installed to the back of the machine.
Placing Originals on the Original Table
• Set one original at a time on the original table.
• If the original's rear edge is badly curled, smooth it out with both hands before scanning. If the
original is inserted as is, it may be damaged.
• When inserting an original, push it lightly against the rollers. Pushing it with force may cause an
original jam.
• When inserting an original, be careful not to put the trailing edge into the entrance of the bypass
tray. This will cause an original jam.
1. Adjust the original guides to the size and orientation of the original.
Make sure the original guides are flush against the original. Do not push the original guide side
fence with force.
DHJ311
Placing Originals
45

Ricoh MP W6700 Specifications

General

Warm-up time	120 seconds
Power source	220 - 240 V, 50/60 Hz
Print Speed	6.7 ppm (A1 horizontal)
Resolution	600 dpi
Maximum Print Width	914 mm
Media Types	Plain paper
Connectivity	USB 2.0, Ethernet 10/100/1000 Base-T
Dimensions	1, 250 x 755 x 1, 200 mm
Original Size	24 inches
Memory	512 MB
Paper weight	52 - 110 g/m²
Supported paper sizes	A4 - A0
Paper input capacity	2 rolls