Message Cause Solution
"Set the Toner Locking Lever
correctly."
The Toner Locking Lever is not set
correctly.
Set the Toner Locking Lever
correctly. For details about how to
set the Toner Locking Lever, see
page 38 "Replacing the Print
Cartridge".
"Specified custom paper
name does not match the
setting. The job has been
cancelled."
Auto job reset by the paper type
name error cured, and printing is
paused.
Press [Exit] to cancel printing.
"Standard Tray is full.
Remove the paper."
The standard tray is full. Remove the paper.
"Supply order has failed." The automatic supply order failed. The message indicates the printer
tried to order the supplies.
"This NetBIOS name is
already in use.(108/208)"
The NetBIOS name specified for
the printer is already used by
another device on the network.
Contact your network
administrator.
"The same IPv4 Address
already exists.(102/202)"
The IPv4 address specified for the
printer is already used by another
device on the network.
Contact your network
administrator.
"The selected job(s) have
already been printed or
cancelled."
This message might appear if you
print or cancell a job from Web
Image Monitor.
Press Exit on the message screen.
"USB has a problem. Please
call service."
The printer has detected a USB
board failure.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
"Values set for IPv6/
Gateway addresses are
invalid.(110/210)"
The IPv6 address or gateway
address is invalid.
Check the network settings.
"Waste Toner Bottle is full or
not set correctly. Please
check the bottle."
The waste toner is full. Replace the waste toner bottle.
For details, see page 42
"Replacing the Waste Toner
Bottle".
3. Troubleshooting
86
To Next Page
Loading...
Need help?
General
Weight and Dimensions
