When Print Quality Is Not Satisfactory
13
STEP1-2 In the case of the media feed quantity is not correct.
1. You have not adjusted feed quantity and drop position.
Adjust the feed quantity correctly, because optimal feed quantity differs for each media.
See the section “Adjusting the Media Feed Quantity " in the manual “Operating Instructions”.
2. The media feed was adjusted in the part where the media has been fed and moved back
or the media is deformed due to heating.
The reversed section of media is damaged by the resist roller and heater.
If you adjust feed quantity in damaged part, uneven density may occur on the media that is
not damaged, because the optimal feed quantity may differ between the damaged part and
the non-damaged part.
If this has happened, press [Origin Setting/Cut] to feed the media until the undamaged
section is under the print heads and perform the media feed adjustment again.
To Next Page
Loading...
Need help?
General