When Print Quality Is Not Satisfactory
9
When Print Quality Is Not Satisfactory
Uneven density (Major case)
Uneven density
[Cause/Technical reason]
In order to use this device with your desirable prints, please set and feed the media correctly.
The device with the stagger head configuration can occur some unacceptable image quality
due to some incorrect media behavior and sensitive skewing.
You can find the factor for uneven density with printed cutter marks. (It does not have to be a
cutter mark, small character or thin line is enough to check the factor.)
[Adding cutter marks]
Using ONIX RIP, you can add the cutter mark in the job.
Right click on the job → Open the “Job Properties” →Open the “Marks” tab → Check the
“Edge marks”
To Next Page
Loading...
Need help?
General