Convenient Usage
53
Reducing media consumption that occurs when loading the
media.
You can reduce the waste media occurring the media set by expanding the media edge to
roll core with the tape.
The procedure that reducing waste media is introduced below.
Caution
This procedure needs to set the media more accurately than the procedure described in the
operating instructions. If the media is skewing, the print image quality significantly reduces.
Procedure
See the operating instructions, carry out the procedure until the media tip come out the cure
heater and roll core is set on the roll-up unit.
Cut a strip about 40 inches (100 cm) long from the PVC media and attach one end to the
center of the media using adhesive tape.
※You can also use commercially available tape.
Cut PVC media thinly
Peel off the base material
Attach one end to the center of
the media using adhesive tape.
To Next Page
Loading...
Need help?
General