152
Figure 11.8-3: Platform Down
Figure 11.8-4: Platform Up
Limit1 should be 0 after Platform UP is selected and 1 when Platform Down is selected.
9: Failed to Calibrate Head Drive Board Voltage
If the printer detects the print voltages are of out of tolerance the printer will attempt to calibrate the
head drive voltage. If the printer is unable calibrate the print heads, the control panel will display a
Voltage Error and prompts the operator decided whether to continue with print. Continuing with print
may result in print discoloration.
Figure 11.9-1: Head Voltages Out of Tolerance
Head Recalibration can be accomplished in the <Diagnostic> Menu under the Print Head tab.
To Next Page
Loading...
Need help?
General