Error and Status Indicate on the Control Panel
Codes on the Screen
• If "C", or "c" appears, contact your sales or service representative.
Code Causes Solutions
E0 A paper jam has occurred in the
machine.
• Remove the jammed paper. See
page 64 "Paper Feed Problems".
E1 Paper has been jammed in the paper
tray.
The input tray has run out of paper.
• Remove the jammed paper. See
page 64 "Paper Feed Problems".
• Load paper to the input tray. See
page 25 "Loading Paper".
E3 A maintenance cover is open. Close the maintenance cover completely.
E4 Front cover is closed. Open the front cover completely.
E5 An appropriate size paper for printing
Report is not loaded.
Load the appropriate size paper.
E6 The print cartridge has not been
installed.
Reinstall the print cartridge. See page 57
"Replacing the Print Cartridge".
E9 An appropriate size paper for making
copies is not loaded.
Load the appropriate size paper.
P1 The paper size set for the document
differs from the size of the paper.
• Press the [Start] key to begin printing, or
press the [Stop/Clear] key to cancel the
job.
• If [Auto Continue:] is set to [0 sec], no
error message appears.
P2 The paper type set for the document
differs from the type of the paper.
• Press the [Start] key to begin printing, or
press the [Stop/Clear] key to cancel the
job.
• If [Auto Continue:] is set to [0 sec], no
error message appears.
8. Troubleshooting
74
To Next Page
Loading...
Need help?
General