Message Cause Solution
"Waste Toner almost full" The waste toner bottle must be
replaced when the waste toner is
full.
Prepare a new waste toner bottle.
"Waste Toner full" The waste toner is full. Replace the waste toner bottle.
For details, see page 37
"Replacing the Waste Toner
Bottle".
"WPA Auth. incomplete.
(211)"
WPA authentication could not be
completed.
Contact your network
administrator.
Alert Messages (Printed on Error Logs and Reports)
This section describes likely causes of and possible solutions for the error messages that are printed on
the error logs or reports.
Message Cause Solution
"84: Error" There is no work area available
for image processing.
Select [Font Priority] for
[Memory Usage] in [System].
Decrease the number of files
sent to the printer.
"85: Error" The specified graphics library is
unavailable.
Check that the data is valid.
"86: Error" Parameters of the control code
are invalid.
Check the print settings.
"91: Error" Printing was canceled by the
auto job cancel function due to
a command error.
Check that the data is valid.
"92: Error" Printing was canceled because
the [Job Reset] key or the
[Suspend/Resume] key was
pressed on the printer's control
panel.
Perform the print operation
again as necessary.
3. Troubleshooting
82
To Next Page
Loading...
Need help?
General
Weight and Dimensions
