Chapter 2 Front Panel Operations RIGOL
DL3000 User’s Guide 2-91
System
Press Utility to enter the system utility function interface. By default, the system
setting tab is selected. As shown in Figure 2-52, if the scrollbar is shown at the right
side of the interface, it indicates that not all system settings are displayed in the
current interface. At this time, press the Up/Down arrow key to go to the next page.
Select the System Language
The interface display, help information, and prompt messages are displayed in both
Simplified Chinese and English. The setting is stored in the non-volatile memory,
which will not be affected even if you restore the load to its factory defaults.
In the system setting tab, press the Up/Down arrow key to switch the parameter
focus to "Language", and then press the Left/Right arrow key or use the knob to
select the desired language: Chinese or English.
Select the Power-on Value
Select "Default" or "Last" as the power-on system state.
Default: restores factory defaults when the instrument is powered on, refer to
Table 2-3.
Last: restores its last state when the instrument is powered on.
In the system setting tab, press the Up/Down arrow key to switch the parameter
focus to "Power-on", and then press the Left/Right arrow key or use the knob to
select the desired power-on state: Default or Last. The setting is saved to the internal
non-volatile memory.
Turn On/Off the Beeper
When the beeper is turned on, the
icon is displayed in the status bar. The beeper
sounds when you perform the following operations.
When you press the keys on the front panel;
When you rotate the knob;
When a prompt message or an alarm is displayed;
When the test is passed or failed.
In the system setting tab, press the Up/Down arrow key to switch the parameter
focus to "Beeper", and then press the Left/Right arrow key or use the knob to turn on
or off the beeper.
To Next Page
Loading...
Need help?
General
