Rigol DL3000 User Manual

RIGOL Chapter 3 Remote Control
3-2 DL3000 User’s Guide
Remote Control via USB
1. Connect the load to the PC
Use the USB cable to connect the load to the PC via the USB DEVICE interface on
the rear panel of the load.
2. Install the USB driver
This load is a USB-TMC device. After you connect the load to the PC properly and
power it on for the first time (the load will be automatically configured with the
USB interface). In this case, "Found New Hardware Wizard" dialog box appears
on the PC. Please install "USB Test and Measurement Device (IVI)" according to
the instructions. The steps are as follows:
1
2
3
4

Rigol DL3000 Specifications

General

Brand	Rigol
Model	DL3000
Category	Measuring Instruments
Language	English