Chapter 2-4
Robomow RL555, RL855, RL2000
Caution! Setting the Perimeter Wire counter-clockwise around
the obstacle will cause Robomow to drive into the island.
P Complete bordering the island and return to the spot that
where you have left the lawn’s edge.
P The wires leading to the Island and returning from it should be
parallel and touching.
BUT DO NOT cross them!
P Peg both wires, to and from the island, together with the
same peg.
Robomow will not recognize these two wires.
It will mow over them as if they do not exist.
Robomow will recognize the single blocking wire around the Perimeter Island
and will not enter this area.
If protected obstacles are grouped closely together, demarcate them by a
single, continuous, Perimeter Island.
If obstacles are close to the edge, leave them out of the mowing area.
2.2.2 Narrow Passes
A narrow pass is part of the lawn which connects two larger zones.
Following the Perimeter Wire, Robomow drives between these zones. But,
it does not cross the pass while mowing each one of them.
P Set the two wires parallel along the pass at a fixed distance of
30 cm (12 inches) between them (Marked on RoboRuler).
If the distance between the wires is smaller than that, the two areas should
be set as 2 separate zones.
Base Zone
Base Zone Base Zone
If wire lays near
a wall or a fence,
keep a distance
of 65 cm (25’’)
between wire and
wall.
Distance of
30 cm (12’’)
between wires.
Especially
important near
pass’ entrances
To Next Page
Loading...
Need help?
General
Weight and Dimensions
