Name: Robomow RL2000
Brand: Robomow
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Chapter 2-12

Robomow RL555, RL855, RL2000

2.11 Completing and Testing the Setup

Once the Perimeter Wire loop is completed and pegged to the

ground, you complete the setup by attaching the beginning and

end of the Perimeter Wire to the Perimeter Switch.

P At the end of the Perimeter Wire’s loop, you have now two

wires: one at the beginning and one at the end of the loop.

Lay the two loose wires in the direction of the Perimeter

Switch location and peg them to the ground using a single peg

for both.

2.12 At the Perimeter Switch’s location:

P Trim the ends of the loose wire (the one without the

connector) to equal lengths and twist them together.

P Strip 5 mm (0.2 inches) of insulation from the wire that is not

connected to the plot connector.

P Insert this wire’s end into the free hole in the connector and

tighten the screws.

P Plug the perimeter wire connector into the Perimeter Switch

(see figure)

P Hold the Perimeter Switch and squeeze its side tabs to remove it from

the back cover.

P Connect the power supply plug to the Perimeter Switch board.

Replace the cover.

P Connect the power supply to a regular household receptacle

230/120 Volts AC.

c IMPORTANT c The Power Supply is for indoor use only.

Choose a sheltered, dry, well ventilated location that is NOT exposed to

direct sunlight, water or rain.

Indoor Use Only

Completing Perimeter Wire

at Perimeter Switch

Questions and Answers:

Need help?

Do you have a question about the Robomow RL2000 and is the answer not in the manual?

Robomow RL2000 Specifications

General