Chapter 4-4
Robomow RL555, RL855, RL2000
4.7 Edge Mowing (Non-Base Zone)
Robomow starts the mowing process by mowing the edges: along the
Perimeter Wire. This creates a clean even cut around the perimeter.
Edge mowing minimizes trimming along walls and other obstacles.
Robomow will always mow the edge in a counter-clockwise direction.
It will automatically find the edge (perimeter), mow it and then turn into
the inner lawn area to complete the mowing.
P Verify that the zone to be mowed is already defined in Robomow.
If the zone is not set yet, do it now (see section 7.4, Work Time).
P Reinsert Manual Controller in its holder.
Adjust the controller and its coil until it is at level with top of Robomow.
P Scroll down (using the DOWN arrow) to select the zone to be
mowed and then press the
once for Edge mowing.
4.8 Scanning (mowing)
Robomow mows your lawn in a systematic scanning motion until all
grass is cut. It runs for the default “MAX” time, or for the amount of
time previously set (See chapter 6, operator settings and advanced
features). “MAX” is typically
2-3 hours of mowing, according to grass type and condition.
4.9 To skip Edge Mowing
If your lawn requires more than two operations per week, it is
recommended to skip edge mowing at the additional operations.
P Move Robomow to any point within the lawn which is at least 1 m
(3 ft) from the Perimeter Wire.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
