Robomow RL2000 User Manual

Chapter 6-3
Charging
6.3 Power Management and Charging Alerts
6.3.1 The Power Pack should be fully charged before starting any
operation.
P Verify that the Power Pack is fully charged before operating it.
P Check for any excessive energy consumers like: dull blades, or heavy
grass accumulation around the blades.
To even increase energy efficiency
6.3.2 Robomow operates under two run-time modes
Robomow’s Power Management System helps protecting its battery.
P Robomow should always be either charging or in operation.
) If Robomow is neither charging nor operating, it will give a
warning, reminding the user to charge it.
) If Robomow is not connected to the charging outlet within a
specific period of time, it will enter a “deep sleep” mode in
order to conserve power.
) In order to wake Robomow up from its deep sleep mode:
remove the Power Pack for 10 seconds and then reinsert it.
6.4 Off-season storage
Preparing Robomow for off-season storage:
P Fully charge the Power Pack.
P Remove Power Pack from Robomow and store it in a dry location at
room temperature.
The Power Pack may be left in a garage or a shed if the temperature there will not
drop below -20 ºC (-4ºF).
P Recharge the Power Pack every three months while in storage.
c Important c For further details of winter storage, please refer to section
10.9.

Robomow RL2000 Specifications

General

Type	Robotic lawn mower
Cutting width	530 mm
Cutting system	-
Recommended lawn area	2000 m²
Maximum cutting height	63 mm
Minimum cutting height	26 mm
Grass collecting volume	- L
Power source	Battery
Charging time	20 h
Battery voltage	24 V
Battery capacity	17 Ah
Cordless	Yes

Weight and Dimensions

Depth	890 mm
Width	665 mm
Height	315 mm
Weight	23700 g