Bottom Panel
8 8
9
8
8
8 Strap pins
Attach the included strap here.
Choose two pin locations as appropriate for your performing
style.
9 Battery compartment
Install eight AA nickel-metal hydride batteries.
&
“Installing the Batteries” (p. 5)
10 Neck control section (Bottom panel)
[PORTAMENTO] button
([S1] button)
Turns portamento on/off.
This produces a smooth change to the next pitch.
[HOLD] button
([S2] button)
Turns hold on/off.
This sustains the notes you play.
[UNISON] button
([S3] button)
Turns unison on/off.
This makes the sound richer by layering the same tone.
* You can change the parameters that are controlled by the [S1]–[S7]
buttons, MODULATION BAR, RIBBON CONTROLLER, control knob,
and pedal.
For details, refer to “Assigning the Function of Each Controller” (p. 12).
Installing the Batteries
Eight AA batteries are required to run the AX-Edge on battery
power. We recommend the use of rechargeable AA-type Ni-MH
batteries. With these batteries you can expect about four hours
of continuous operation, although this depends on how the AX-Edge
is being used.
* When turning the unit over, be careful so as to protect the buttons and
knobs from damage. Also, handle the unit carefully; do not drop it.
* If you handle batteries improperly, you risk explosion and fluid leakage.
Make sure that you carefully observe all of the items related to batteries
that are listed in “USING THE UNIT SAFELY” and “IMPORTANT NOTES”
(leaflet “USING THE UNIT SAFELY” and Owner’s manual (p. 22)).
1.
Turn off the power of the AX-Edge (p. 8).
2.
While pressing inward on the tabs of the bottom panel
battery compartment cover, remove the cover.
(a) While pressing the tabs
(b) Lift up
3.
Insert the batteries into the battery compartment, taking
care to observe the “+” and “–” polarity.
Be sure that the “+” and “-” markings on the batteries are
oriented correctly.
4.
Close the battery compartment cover.
page 10
page 10
page 11
5
Owner’s Manual
To Next Page
Loading...
Need help?
General
