Playing
Selecting a Sound (Program)
The sounds (programs) of the AX-Edge are organized into ten
category, with 32 programs in each category.
1.
Press the [EDGE LEAD]–[VOCODER/VOICE] buttons to
select the category.
2.
Use the [–] [+] buttons to switch programs.
Category number Program number within the category
MEMO
5
If you keep on holding down one button while pressing the other, the
value change accelerates.
5
You can also switch categories by holding down the [SHIFT] button
and using the [–] [+] buttons.
5
You can switch programs by using the PROGRAM [–] [+] buttons
located in the neck control section.
Registering Frequently-Used Sounds
to Buttons (FAVORITE)
“Favorite” is a function that lets you register frequently-used
sounds (programs) so that they can be recalled by a single button.
The Favorite registers the number of the program.
Favorite Bank 9
Favorite Bank 0
Favorite 0–9
MEMO
5
With Favorites 0–9 as one set, you can register a total of ten sets in the
Favorite banks.
5
Use the ten buttons [0]–[9] to recall or register programs.
NOTE
If you’re editing a program, save that program first before you register
it as a Favorite.
Registering a Favorite
1.
Select the program that you want to register.
2.
Press the FAVORITE [BANK] button to make it light.
3.
Press a [0]–[9] button to select the registration-
destination bank.
4.
Hold down the FAVORITE [ON] button and press the [0]–
[9] button in which you want to register the program.
The currently selected program is registered to that button.
Recalling a Favorite
1.
Press the FAVORITE [ON] button to make it light.
The [0]–[9] buttons act as Favorite select buttons.
When the FAVORITE function is on, the bank/number display
shows the following.
1 - 3
Bank number Favorite number
2.
Press a [0]–[9] button to select a Favorite.
If you press a button in which a Favorite has not yet been
registered, the screen indicates “Not Registered!”
Switching the Favorite Bank
1.
Press the FAVORITE [BANK] button to make it light.
The button ([0]–[9]) corresponding to the currently selected
bank blinks.
2.
Press a [0]–[9] button to select a bank.
MEMO
If only the bank number is shown in the display, use the [0]–[9] buttons
to select a favorite.
9
Owner’s Manual
To Next Page
Loading...
Need help?
General
