24
QUALITY
NORMAL HEAVY
HEAVY NORMAL HI-SPEED
Emphasis
on Quality
Priority
on Speed
• When you want
cutting to be as
attractive as possible
• When heavy material
is loaded
• When you want to cut
as rapidly as possible
(used together with
cutting speed)
QUALITY
NORMAL
UPSPEED
50cm/s 40cm/s
QUALITY
NORMAL HEAVY
Setting range:1 to 85 cm/s
(in incre-
ments of 1
cm/s)
Adjusting the Up Speed
3
Press the [ ] key to move to the setting screen, then
use the [
] and [ ] keys to enter the up speed.
4
Press the [ENTER] key to enable the up speed.
5
Press the [ ] key to exit the menu mode.
Settings for Cutting Quality
You can select whether speed is given priority in cutting, or whether cutting quality is emphasized.
This is also effective in preventing misalignment and motor errors when cutting heavy material.
1
Press the [MENU] key to enter the menu mode.
2
Press the [ ] key several times until the screen shown
at right appears.
Setting range:NORMAL,
HEAVY, HI-
SPEED
Adjusting Cutting Quality
3
Press the [ ] key to move to the setting screen, then
use the [
] and [ ] keys to select the cutting quality.
4
Press the [ENTER] key to enable the cutting quality.
5
Press the [ ] key to exit the menu mode.
To Next Page
Loading...
Need help?
General
