54
9-2 What to do if...
Is the power cord connected correctly? Connect the power cord included with the CX-500/400/300 to the unit, and plug
the other end securely into an electrical outlet (see “3-2 Connection”).
CX-500/400/300 Troubleshooting
Is the CX-500/400/300 power on ? Turn on the power.
Is the CX-500/400/300 in the temporary
halt state ? Is operation paused?
If the screen shown at rights is displayed,
it means that operation is paused.
To resume cutting, press the [PAUSE] key again.
To abort cutting, first stop the flow of cutting instructions from the computer.
Then hold down the [ENTER] key for 0.5 seconds or longer.
Are the computer and the CX-500/400/
300 linked with the right cable ?
The type of cable you need is determined by your computer and the software you
are using. Even if the computer is the same, running different software may require
a different cable. Use the cable specified in your software.
Is the machine in the setup state? If the SETUP LED is not lit, cutting cannot be performed even when data is sent.
Are the settings for the software driver
correct?
Make the correct settings for the output port.
Are the computer and the CX-500/400/
300 connected correctly?
Correctly connect the computer and the CX-500/400/300 (see “3-2 Connections”
).
Is the OS set up correctly ? Check the following items:
• Output port selection • Output device selection • Other settings
Check the OS’s user’s manual and set it up correctly.
Are the application software settings
correctly ?
When specifying the output device, select the name of a model that supports the
instruction set. If the instruction set is different, completely different instructions
may be sent, resulting in an error. Settings for the output origin point and the like
may also be required.
Check the software user’s manual and set it up correctly.
Is the machine in the menu mode?
When the menu is displayed, cutting is not performed even when data is received.
Quit the menu mode.
CONTINUE PAUSE
STOP ENTER
To Next Page
Loading...
Need help?
General