25
5-2 Details of the Origin-point Location and Cutting Area
The Location of the Origin Point Immediately After Loading Material
With the CX-500/400/300, the initial origin point is determined when you load material and press the [ENTER] key. The origin point
that is initially determined when you press the [ENTER] key differs according to the selection made for [SELECT SHEET] with the
operation panel when loading material.
[ROLL] Set near the left-hand pinch roller
[PIECE] Material size is detected and the origin is set at the lower-left area of the material
[F-EDGE] Set at the front left edge of the material
[R-EDGE] Set at the inner left edge of the material (When using the “Front loading”)
For more information, see the following page.
* When [AXIS ROTATE] is set to [90deg], the initial origin point is set at the lower right with the X and Y axes rotated 90 degrees.
To Next Page
Loading...
Need help?
General