41
6-2 About Special Materials
[About the Separating Knife]
It may not be possible to sever some thicker materials (such as rubber sandblasting templates) or thin, flimsy materials.
Material with a strong tendency to reroll (that is, with a warp in the direction of the cutting surface) may catch on the carriage after
being cut off. Do not sever those materials with the separating knife.
[Rubber materials for sandblasting stencils which can be cut]
A) Materials with a material thickness of 1 mm (0.04 in.) or less
B) Materials with only carrier paper on both flanks of the material (Position the left and right pinch rollers above the strips of carrier
paper.)
C) Materials with carrier paper which is hard enough to withstand material feed
A) 1 mm (0.04 in.) or less
Carrier paper
Material
B) 15 mm (5/8 in.) or moreB) 15 mm (5/8 in.) or more
[Material with sprocket-feed holes]
Material for sprocket-feed use has feed holes along both
edges.
If the material is loaded with these holes lying over the pinch
rollers, material feed cannot be performed correctly.
When you are using this with the CX-500/400/300, load it as
shown in the figure.
To Next Page
Loading...
Need help?
General