46
Chapter 3 - Preparations
Lock nut
Lock nut: Loosen
[AUTO Z CONTROL]: ON
[REVOLUTION]: OFF
Diamond scraper
Cutter holder (included with a diamond scraper)
Tool securing
screw
Solid collet for a diamond scraper (optional)
3-4. Cutter Installation Method 3 (Diamond Scraper)
This is for when you scribe aluminum or brass plates. The tool used is a diamond scraper, and the spindle is not rotated.
Engraving is performed by scraping the workpiece, so it achieves attractive finished results with little burring, but it does
not obtain deep cutting-in.
An optionally available solid collet for diamond scrapers is required to install a diamond scraper.
To Next Page
Loading...
Need help?
General