ENGLISH
114114
Troubleshooting
Moisture Condensation
Self Diagnosis Display
✤ Before contacting a Samsung authorized service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
✤ If the Camcorder is brought directly from a cold place to a warm place, moisture may condense inside the Camcorder,
on the surface of the tape, or on the lens. In this condition, the tape may stick to the drum head and be damaged or the unit
may not operate correctly.
The Camcorder is fitted with a moisture sensor to resist damage under these circumstances.
✤ If there is moisture inside the Camcorder, (DEW) is displayed. If this happens, none of the functions except cassette
ejection will work.
Open the cassette compartment and remove the battery.
Leave the Camcorder in a dry, warm room for at least two hours.
slow
slow
no
slow
slow
slow
slow
the Battery pack is almost discharged. Change to a charged one.
When the remaining time on the tape
is about 2 minutes.
Prepare a new one.
the tape reached its end.
Change to a new one.
there is no tape in Camcorder.
Insert a tape.
the tape is protected from recording.
If you want to record, release
the protection.
moisture condensation has formed in
the Camcorder.
see below.
the Camcorder has some mechanical
fault.
1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your local
Samsung service center.
Tape end !
Tape end !
No Tape !
Protection !
....D
L
C
R
Display
Blinking Informs that... Action
Troubleshooting
To Next Page
Loading...
Need help?
General
