www.schaerer.com
13
BASCA - EN
Version 06 01.2010
Commissioning
Setup conditions
Location
• Before setting up the device, make sure that the coffee maker will not be standing on hot surfaces or
close to ovens.
The machine is not suitable for outdoor use. Never expose the coffee maker to external weather condi-•
tions such as rain, snow, frost, etc.
The coffee machine is not suitable for installing on a surface which is cleaned by a hose.•
Only install the device in a location where it can be observed by trained personnel.•
The installation surface must be stable and flat, and must be able to bear the weight of the coffee machine •
without changing shape.
Climatic conditions
The installation location must meet the following climatic conditions:•
Ambient temperature of 10°C – 40°C (50°F – 104°F)•
Relative humidity of no more than 80 % rF•
The coffee machine is solely designed for indoor use.•
Protect the device from frost. If the coffee maker has been exposed to minus temperatures, contact a •
customer service representative authorized by the manufacturer before using the machine.
Power supply
Model
Power rating
Fuse (installation
site)
Connection cable
conductor cross-
section
SCA1 220-240V~ 50/60 Hz
2000-2400 W 1 x 10 A 3 x 1,0 mm²
3000-3600 W 1 x 16 A 3 x 1,5 mm²
SCA1/MSC 220-240V~ 50/60 Hz
2000 - 2400 W
10A 3x 1 mm²
100 W
SCA1 USA 200-220V 2~ 50/60 Hz 4700-5800 W 1 x 30 A 3 x 10 AWG
SCA1 Japan 200-220V 2~ 50/60 Hz
2000-2200 W
2 x 15 A 3 x 1,5 mm²
2600-3200 W
SCA1 Korea 220V~ 50/60 Hz 3200 W 1 x 16 A 3 x 1,5 mm²
The device must be electrically connected according to all valid regulations (VDE 0100) as well as national
stipulations. The type of power cable must be at least H 05 VV-F. The voltage specified on the serial plate
must match the supply voltage at the installation location.
The phase must be protected from short-circuits with the Ampere value mentioned on the serial plate!
All poles of the device must be able to be disconnected from the power supply.•
Never operate a device with a faulty power cord. Have a defective power cord or plug replaced immedi-•
ately by a qualified service technician.
Schaerer Ltd. advises against the use of extension cables! • If an extension cable must be used, nev-
ertheless (minimum cross-section: 1.5 mm2), please observe the cable manufacturer’s data (instruc-
tions for use) and all local regulations.
Power cords must be connected in such a way that no one can trip over them. Do not pull the cords over •
corners or sharp edges, pinch them between objects or allow them to hang loosely in a room.
Do not place cables over hot objects, and protect them from oil and aggressive cleaning agents. Never •
lift or pull the device by its power cord. Never pull the plug out of the socket by its cord. Never touch the
power cord or plug with wet hands! Never insert a wet plug into a power socket!
CAUTION!
Machine at risk!
CAUTION!
Electrocution!
To Next Page
Loading...
Need help?
General
