www.schaerer.com
19
BASCA - EN
Version 06 01.2010
Operation – Steam cup heater (option only for Switzerland)
Pre-heating cups
Press the defined beverage button (the steam cup heater will be activated). ►
Place the cup upside down onto the steam cup heater and push it down for ± 5 seconds. ►
Press the defined beverage button again (the steam cup heater will be deactivated) ► .
Beverage output
Adjusting outlet height
Adjust the outlets to the correct height before dispensing any beverages! If a beverage has al-
ready been dispensed, the outlet may be warm!
There is a risk of squeezing ngers when moving the outlet!
Hold the front of the outlet and move it to the desired position (see picture). ►
Adjustable tray height: 65 - 185 mm
Preparing coffee beverages
All beverages dispensed from the machine are hot! Do not reach under the outlet while a beverage
is being dispensed!
Place a cup under the outlet. ►
Move the outlet to the correct position. ►
Press desired beverage button (LED next to the pressed button blinks green). ►
After the beverage has been dispensed (LED stops blinking) remove the cup. ►
If programmed, the machine has two possible product layers for each button. To enter the second product
level press the SHIFT button before the product selection.
Preparing milk beverages
If programmed, milk beverages can also be dispensed using the beverage buttons.
Cappuccino•
Latte Macchiato•
Latte•
Hot milk, cold milk and milk foam)•
Moccaccino (option powder doser)•
CAUTION!
Hot steam!
CAUTION!
Hot surface!
CAUTION!
Risk of squeezing!
CAUTION!
Hot fluit!
To Next Page
Loading...
Need help?
General
