Segway x2 SE Service Manual

Segway Personal Transporter SE Service Manual
2–2
Mats
Mats
Removal
1. Make sure the PT is powered off and unplugged.
2. Lift the Mat off the Powerbase. See Figure 2–1.
Installation
1. Make sure the PT is powered off and unplugged.
2. Verify that the top of the Powerbase and the bottom
of the Mat are clean, dry, and free of debris.
3. Place the Mat on the Powerbase.
4. Fit the Mat’s rubber tabs into the slots formed by
the gap between the front and rear fascia and the
Powerbase. See Figure 2–1.
5. Visually confirm that the Mat is properly aligned and
all rubber tabs are tucked in prior to riding.
6. Perform post-service tests (page A–1).
Figure 2–1: Mat Installation

Segway x2 SE Specifications

General

Brand	Segway
Model	x2 SE
Category	Scooter
Language	English