Operating Instructions
LMS1xx Laser Measurement Sensors
Mounting
8012471/ZN27/2017-06-09 © SICK AG · Germany · All rights reserved · Subject to change without notice 63
Chapter 5
Fig. 41: Placement of two LMS1xx with parallel offset, one of these upside down
Fig. 42: Placement of two LMS1xx upside down, parallel offset
Fig. 43: Placement of two LMS1xx with parallel offset, one of these upside down
5.4 Dismantling the LMS1xx
1. Switch off the supply voltage.
2. Loosen and remove the connection cables.
3. Undo the mounting screws for the LMS1xx to the mounting bracket and remove the
device.
Important On final decommissioning, please observe the disposal requirements in section 8.3.1
“Disposal” on page 88 for environmentally correct disposal.
To Next Page
Loading...
Need help?
General
