Siemens HiPath Series User Manual

Using Other Functions
81
Step by Step
Using System Functions from the Outside
(DISA: Direct Inward System Access)
If this function has been configured (contact your serv-
ice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code: #0 Æ Page 79
• Call forwarding, code:
*
1/#1 Æ Page 21
• Lock and unlock all phones,
code:
*
66/#66 Æ Page 69
•Save PIN,
code:
*
93 Æ Page 71
• Send a message,
code:
*
68/#68 Æ Page 72
• Leave an advisory message,
code:
*
69/#69 Æ Page 74
• Group ringing, code:
*
81/#81 Æ Page 87
• Group call, code:
*
85/#85 Æ Page 87
• Suppress caller ID,
code:
*
86/#86 Æ Page 67
• Waiting tone, code:
*
87/#87 Æ Page 47
• Open door, code:
*
61 Æ Page 32
• Door opener on/off, code:
*
89/#89 Æ Page 32
• Control relay, code:
*
90/#90 Æ Page 85
• Do not disturb, code:
*
97/#97 Æ Page 66
• Ringer cutoff function, code:
*
98/#98 Æ Page 66
• Speed-dialing, code:
*
7 Æ Page 37
• Associated service, code:
*
83 Æ Page 80
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o Set up a call to the system. Enter the station number
(contact your service personnel).
o Wait for a continuous tone (if necessary switch the tel-
ephone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r Enter the code (necessary only if programmed in the
system).

Siemens HiPath Series Specifications

General

Brand	Siemens
Model	HiPath Series
Category	Telephone
Language	English