Siemens RWF50.3 User Manual

34/64
Building Technologies Division User Manual RWF50... CC1U7866en
Infrastructure & Cities Sector 6 Operation 25.07.2014
6.3 User level
This level is started from the basic display.
Setpoints SP1, SP2 or dSP can be altered.
The values of InP (analog input) and Y (current angular positioning between 0...100%)
can be displayed.
*
From the basic display, press
Enter
so that OPr appears
*
Press
Enter
so that SP1 appears
*
Press
Enter
and SP1 flashes
*
Press
or
to adjust the required setpoint and press
Enter
to confirm
Timeout after about 180 seconds.

Note!
If the setpoint is not stored, the basic display changes after the timeout tout and the
former setpoint is maintained.
The value changes only within the permitted range.
Changing the setpoints
Timeout

Siemens RWF50.3 Specifications

General

Brand	Siemens
Model	RWF50.3
Category	Controller
Language	English