Commissioning
7.4 Setting up the Microsoft Windows operating system
SIMATIC HMI IPC677C
Operating Instructions, 04/2013, A5E02722710-04
61
7.4 Setting up the Microsoft Windows operating system
Introduction
The setup wizard appears immediately following the startup of the device. The wizard is
used to set the parameters of the operating system.
Note
The dialogs of the setup wizards differ slightly in some places for the Windows operating
systems.
In order to change to the next dialog, click on the ">>" button. In order to change the entry in
the previous dialog, click on the "<<" button.
Procedure
1. Accept the Microsoft licensing agreement.
2. Leave the regional settings of the operating system unchanged. If required, adjust the
regional settings of the operating system only after commissioning.
3. Enter the company names and user names.
4. If this PC name is already in use as you attempt to connect the device to a network: Enter
a new PC name for identification.
The operating system will restart automatically.
The system settings are updated. The desktop is set up. The setup of the operating system
is complete.
7.5 Windows XP and Windows Embedded Standard 2009
First commissioning
● The "SIMATIC PC Wizard" program is automatically started once during the first
commissioning.
● The wizard will automatically set the device-specific drivers and applications at the initial
start of the operating system.
● The hardware is detected automatically.
To Next Page
Loading...
Need help?
General
