Machine data
2.3 Channel-specific machine data
Parameter Manual
174
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
The program run time is measured using system variables and can be read out.
It provides a means of outputting the current progress of the processing of a
part program. This MD can be used to make the following settings on a chan-
nel-specific basis:
Bit 0 = 0
$AC_ACT_PROG_NET_TIME is not deleted on a jump to the start of the pro-
gram with GOTOS
Bit 0 = 1
$AC_ACT_PROG_NET_TIME is deleted on a jump to the start of the program with
GOTOS, the value is saved in $AC_OLD_PROG_NET_TIMES, and the program counter
$AC_OLD_PROG_NET_TIME_COUNT is incremented.
Bit 1 = 0
$AC_ACT_PROG_NET_TIME ceases to be increased if override = 0 is set; in
other words, the program run time is measured without the time for which the
override was set to 0.
Bit 1 = 1
$AC_ACT_PROG_NET_TIME is increased if override = 0; in other words, the
program run time is measured with the time for which the override was set to
0.
Bits 2 to 31
Reserved
27850 PROG_NET_TIMER_MODE C09 -
- Impact of the program runtime net counter DWORD Reset
-
- - 0x01 0x00 0x03 1/1