Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
71
Machine data
2.2 General machine data
Description: This machine data defines which stop reasons are to be ignored on an ASUB
start. The ASUB is started or the following stop reasons are ignored:
Bit 0:
STOP reason: STOP key, M0 or M01
An ASUB is started immediately if NCK is in RESET status (or JOG mode) (no
ASUB can be started in RESET/JOG without this bit).
Bit 1:
Reserved! This bit was replaced by MD20105 $MC_PROG_EVENT_IGN_REFP_LOCK and
MD20115 $MC_IGNORE_REFP_LOCK_ASUP.
Bit 2:
Start allowed even if a read-in disable is active; in other words, the blocks
of the ASUB program are loaded and executed immediately. This therefore dis-
ables machine data MD20107 $MC_PROG_EVENT_IGN_INHIBIT and MD20116
$MC_IGNORE_INHIBIT_ASUP. The NCK behavior corresponds to the machine data
assignment $MC_PROG_EVENT_IGN_INHIBIT=H3F $MC_IGNORE_INHIBIT_ASUP=HFFFFFFFF.
If the bit is not set:
The assignment of machine data MD20107 $MC_PROG_EVENT_IGN_INHIBIT and MD20116
$MC_IGNORE_INHIBIT_ASUP are evaluated.
If the particular bit in $MC_PROG_EVENT_IGN_INHIBIT or
$MC_IGNORE_INHIBIT_ASUP is 0, then although an ASUB or prog event are immedi-
ately internally initiated, the blocks of the ASUB program are only loaded
when the read-in inhibit is withdrawn.
The path is decelerated immediately when the ASUB is triggered (except with
option BLSYNC).
The read-in disable is set once more in the ASUB program.
Bit 3:
If an ASUB is started automatically from JOG, the user may stop in the middle
of the ASUB program. JOG mode is displayed continuously for the user. With
bit 3 set, the user may jog in this situation. This is not possible without
bit 3. In this case, mode change is locked with alarm 16927. By pressing the
Start key, the user can continue the ASUB program. As long as the ASUB pro-
gram is running, the user is naturally not able to jog. At the end of the
ASUB program, the user may jog again.
Bit 4...15:Reserved
Corresponds with:
MD11604 $MN_ASUP_START_PRIO_LEVEL
MD20105 $MC_PROG_EVENT_IGN_REFP_LOCK
MD20107 $MC_PROG_EVENT_IGN_INHIBIT
MD20115 $MC_IGNORE_REFP_LOCK_ASUP
MD20116 $MC_IGNORE_INHIBIT_ASUP
11602 ASUP_START_MASK N01, - K1,M3,TE3,TE7
- Ignore stop conditions for ASUB DWORD PowerOn
-
- - 0x01 0 0xf 1/1
Siemens Controls
To Next Page
Loading...
Need help?
General
