15.3 Displaying messages
PLC and part program messages may be issued during machining.
These message will not interrupt the program execution. Messages provide information with
regard to a certain behavior of the cycles and with regard to the progress of machining and
are usually kept beyond a machining step or until the end of the cycle.
Overview of messages
You can display all issued messages.
The message overview contains the following information:
● Date
● Message number
is only displayed for PLC messages
● Message text
Procedure
1. Select the "Diagnostics" operating area.
2. Press the "Messages" softkey.
The "Messages" window appears.
Alarm, error, and system messages
15.3 Displaying messages
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 813
To Next Page
Loading...
Need help?
General
