6 MENU SCREENS
The menu structure on the SDM630 is configurable using the FPP. A system
administrator usually tailors the order and presence of the menu options to specific
customer requirements.
This section describes all the menus that are currently available.
Normally, the menus are divided into three menu lists. These are the Main Menu list,
the Setup Menu list and the User Options Menu list.
In the default configuration, the Main Menu contains the Channel, Zone and Setup
menus. This allows access to the second ‘Setup’ menu level.
The Main Menu can be accessed from the default screen by selecting the ‘Menu’ (F1)
button.
To access any of the menu options from the Main, Setup or User Options Menus, use
the ▲ and ▼ keys to scroll through the lists until the required menu option is
selected with the pointer (►) and then press the ‘S’ (F1) button.
Pressing the ‘B’ (F4) key at any point will go back to the previous screen.
6.1. CHANNEL MENU
Figure 5: Channel Screen.
The Channel Screen shows the currently selected channel. Other channels can be
selected with the Up/Down keys.
Radio channels may be configured with the FPP as specific frequencies or as auto-scan
types. When an auto-scan channel is selected, it will immediately go into scan mode.
Selecting another non-auto-scan channel will stop the scan.
Doc Number: TNM--U-E-0108 ISSUE 1.5 Page 38
To Next Page
Loading...
Need help?
General
