The top part of the screen shows if any diversion are in place, while the lower part of
the screen provides the divert options.
Use the ▼ and ▲ keys to select the required divert option. Pressing the ‘S’ key will
initiate the diversion setup.
When setting up a diversion, the ID number of the radio entity to which the calls/data
are to be diverted can either be entered manually (Custom) or selected from the
Contact list (Contact).
6.18.1. To Setup a Diversion
To Divert Calls, Data Messages or both, carry out the following:
1. On the Call Divert screen, use the ▼ and ▲ keys to select the required divert
option. Press the ‘S’ key to start the relevant divert setup. The Call Divert –
Target Type screen will be displayed.
Figure 34: Call Divert – Target Type screen.
2. On the Target Type screen, using the ▼ and ▲ keys, select ‘Custom’ to enter
the radio ID manually or select ‘Contact’ to choose the radio ID from the contact
list. Press the ‘S’ key.
3. If the Custom option is selected, the Call Divert – Enter Target screen will be
displayed.
Figure 35: Call Divert – Enter Target screen.
Doc Number: TNM--U-E-0108 ISSUE 1.5 Page 54
To Next Page
Loading...
Need help?
General
