50
M
Mark the design on the fabric. Insert the cord in
the center groove of the cording foot from the
right side opening. Pull the cord about 5cm (2
inches) behind the foot.
The grooves of the foot will hold the length of
the cord in place while the stitches are being
formed over the cord.
Select the stitch and adjust the stitch width so
that the stitches are just covering the cord.
Lower the foot and sew slowly, guiding the cord
over the design.
Single cording
Sew over one, two or three strands of cord to embellish fabrics. Pearl cotton, embroidery floss or fine
wool yarn can be used for cording.
M
Triple cording
Push the sewing thread to the left and insert
three cords into the grooves of the foot and pull
about 5cm (2 inches) of the cords behind the
foot. Select the desired pattern and adjust the
stitch width so that the stitches are just covering
the cords. Lower the foot and sew slowly
guiding the cords.
5
6 B-15
CORDING
* The Cording foot is an optional accessory.
To Next Page
Loading...
Need help?
General
