STEP 4: CONNECT POWER
Your Slayer Steam X machine will ship with the power configuration
requested at the time of purchase. In most cases, this will include a
plug end on the power cord. If your machine does not include a plug,
do not attempt to wire it yourself. Only an electrician or approved
technician should wire the power cord into an appropriately-rated
plug end.
INCLUDED PARTS
• External rotary pump
PROCEDURE
1. Ensure that both steam actuators are in the “off” position and the
drain hoses and water lines are connected (per previous steps).
2. Insert the main power plug into an appropriately-rated and
grounded receptacle
3. Locate the quick connect plug, found on one of the electrical cords
that extends from your machine, and insert it into the matching
plug unit on the pump motor. Do not move the steam
actuators to the “on” position.
Do not turn on the main water supply.
Main power
Quick connect plug
Purge
Off
On
SLAYER STEAM X USER MANUAL V1.1 | SEPTEMBER 2019
14
To Next Page
Loading...
Need help?
General
