HGM400 Series Genset Controller User Manual
HGM400 Series Genset Controller ISSUE 2015-05-27 Version 1.6 Page 7 of 44
Fuel Level (FL) % (Unit)
Engine Speed (RP) RPM (Unit)
Battery Voltage (VB) V (unit)
Charger Voltage (VD) V (unit)
Hours Counter (HC): Max. 999999 hours
Start times: Max.999999 times
Control & Protection: automatic start/stop of the genset, ATS(Auto Transfer Switch)
control with perfect fault indication and protection function;
With ETS(Energize To Stop), idle control, pre-heat control, speed raise control and
speed drop control function, All output ports are relay-out;
Parameter setting: parameters can be modified and cannot be lost even in case of
power outage; all the controller parameters can be adjusted using front panel of the
controller or via PC using an SG72 adaptor.
Multiplex input port 3 and 4 can be used in various fields: input 3 can be used as
auxiliary input port or fuel level sensor while input 4 can be used as auxiliary input
port or configurable sensor.
More kinds of curves of temperature, oil pressure, fuel level can be used directly
and users can define the sensor curves by themselves;
Configurable sensor: can be set as temperature sensor, oil pressure sensor or fuel
level sensor, enable the detection of double temperature, double oil-pressure and
double fuel level.
Multiple crank disconnect conditions (magnetic pickup, oil pressure, generator
frequency) are optional;
Widely Power supply range: DC(8~35)V, suitable to different start battery voltage
environment.
All parameters used digital adjustment, instead of conventional analog modulation
with normal potentiometer, more reliability and stability;
Modular design, self-extinguished ABS plastic enclosure, pluggable connection
terminals and embedded installation way; compact structure with easy mounting.
To Next Page
Loading...
Need help?
General
