SMC Networks Barricade N SMCWBR14S-N4 User Manual

C HAPTER 3 | Installing the Gateway Router
Mounting on a Wall
– 34 –
MOUNTING ON A WALL
The Wireless Broadband Router should be mounted only to a wall or wood
surface that is at least 1/2-inch plywood or its equivalent. To mount the
unit on a wall, always use its wall-mounting bracket. The unit must be
mounted with the RJ-45 cable connector oriented upwards to ensure
proper operation.
Figure 8: Wall Mounting
To mount on a wall, follow the instructions below.
1. Mark the position of the two screw holes on the wall. For concrete or
brick walls, you will need to drill holes and insert wall plugs for the
screws.
2. Insert the included screws into the holes, leaving about 0.08~0.12
inches (2-3 mm) clearance from the wall.
3. Line up the two mounting points on the unit with the screws in the wall,
then slide the unit down onto the screws until it is in a secured position.
Mounting Slots

SMC Networks Barricade N SMCWBR14S-N4 Specifications

General

Brand	SMC Networks
Model	Barricade N SMCWBR14S-N4
Category	Wireless Router
Language	English