129
6-3 Manual Editing
Chapter 6 Editing
6-3 Manual Editing
Follow the procedure below to perform manual editing.
1
Enter jog or shuttle mode to position the tape at a place
at least three seconds before the position at which you
want to set an edit point.
2
Press the AUTO button to turn it off.
3
Press the [F3] (ASSEMBLE) button in the HOME
menu or press the respective INSERT button ([F4]
(INS TC), [F5] (INS VIDEO) or [F6] (INS AUDIO)
button) to select the edit mode that you want.
4
Press the PLAY button.
Playback starts.
5
Press the REC/EDIT button at the point where you
want to start editing (IN point).
The REC/EDIT button lights, and editing starts.
6
Press the REC/EDIT button at the point where you
want to end editing (OUT point).
Editing ends, but the tape continues to run in playback
mode.
7
Press the STOP button to stop the tape.
To ensure a stable picture, start playback at least three
seconds before the IN point.
Note
4 5,67
21
3
To Next Page
Loading...
Need help?
General
