Chapter 5 Control From Editing
Control Units
5-8 Chapter 5 Control From Editing Control Units
Control From the BVE-900/2000 Series
You can combine the DFS-700/700P with a BVE-900/910 or BVE-2000
Series Editing Control Unit to carry out A/B roll editing using two players
and one recorder.
For details of preread editing, see the section “Preread Editing” (page 5-14).
Connectable editing control units
To control the DFS-700/700P, the BVE-900/910/2000 and optional BKE-
913 board (for BVE-900/910) must have the following ROM versions or
higher.
BVE-900 Ver. 1.11 or later
BVE-900 with BKE-900K Ver. 2.01 or later
BVE-910 Ver. 1.02 or later
BKE-913 Ver. 1.06 or later
BVE-2000 Ver. 1.10 or later
Control using editor control signals
You can control the following DFS-700/700P functions using 9-pin serial
control signals from the BVE-900/910/2000. Input these signals to the
EDITOR connector on the rear panel of the DFS-700/700P. The functions
marked with an asterisk below can only be controlled from the BKE-900
after installation of the optional BKE-900K board.)
•Background image (FROM source) and foreground image (TO source)
selection
•Pattern number selection
•Transition direction (normal or reverse) selection
•Transition duration selection
•Automatic transition execution
•Downstream key on and off
•Snapshot saving and recall*
•Saving and loading DFS-700/700P data (snapshots and user program
effects)*
Notes
•It is not possible to load and save user program effects or snapshots from
the BVE-900/910.
•KEY FADE IN and KEY FADE OUT cannot be used. Also, KEY WIPE
OUT and KEY MIX OUT can only be used with versions 2.24 and later
of the BVE-2000.
When using KEY WIPE OUT, the effect must be executed in the reverse
direction.
To Next Page
Loading...
Need help?
General
