Chapter 6 System Connections and
Settings
Chapter 6 System Connections and Settings 6-7
Setup Menu Settings
Setup Menu Organization
The setup menu is divided into eight pages, and each appears as shown in
the following example.
Example display:
SYS
P 1/8
SCREEN
4:3
PRE RD
OFF
PORTS
PVE500
TALLY
OFF
CpnIN
IN 4
System Setup (page 1/8)
a)The SCREEN setting cannot be saved in memory.
F3(PORTS) setting and control
Menu name
Settings
Page
Values
To submenu
Button
Setting Meaning Values
(First value is factory default.)
F1
SCREEN
a)
Set screen aspect ratio. 4:3/16:9
F2 PRE RD Toggle preread editing on/off.
When this is on, a “P” appears at the
beginning of line two of the menu
display.
OFF/ON
F3 PORTS Select type of editor connected to
EDITOR connector.
(See table below.)
PVE-500/BVE-600/GPI
(Select “PVE500” when a BVE-2000 is
connected.)
F4
TALLY Toggle rear panel tally output signal on/
off.
OFF/ON
F5
CpnIN
(Only appears when
optional BKDF-702/702P
is installed.)
Assignment of
numbers to rear panel
COMPONENT
connectors
5
/1 to
8
/4
IN1-4 r: assign 1
to 4.
1-4/5-8
To confirm displayed assignment, press
F3(OK); to cancel press F5(CANCEL).
IN5-8 r: assign 5
to 8.
Values Valid control for each connector
EDITOR connector GPI/T 1 GPI/T 2
PVE-500 DVS control – DSK transitions
BVE-600 – Auto transitions
GPI – Auto transitions DSK transitions
A “P” appears here when
preread editing is on.
To Next Page
Loading...
Need help?
General
