Chapter 3 Basic Operation
Chapter 3 Basic Operation 3-23
Selection in Direct Pattern Selection Mode
In the direct pattern selection mode, pressing any button (other than INS,
DEL, UP, DOWN, or ENTER) in the pattern/numeric keypad directly
selects an effect pattern.
For details of the effects assigned by factory default to the buttons in the pattern/
numeric keypad, see the previous section “Example Effects” (page 3-18).
Procedure
To select an effect pattern in the direct pattern selection mode, use the
following procedure.
Note
If the EDIT button in the user program section (see page 2-11) is lit, first
press it, turning it off.
1 Press the DIRECT PATTERN button, turning it on.
The unit is now in direct pattern selection mode.
2 In the pattern/numeric keypad, press the button assigned to the desired
effect pattern, turning it on.
This selects the effect assigned to the button, and the pattern number
appears in the PATTERN NUMBER display window.
LAST X
INS
RST
TITLE
12
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDER BEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDERMATTES
LOCATION
LEARNEDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN
ADJ
PAGE
F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB
SET
TRANS RATE
789
456
123
0
DOWN UP
ENTER
FADE
TO
BLACK
P IN P
DSK
DEL
N/R REV DSK PVWDIRECT
RECALL
DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL
SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE
12345678
CUT
AUTO
TRANS
AUXILIARY
BLACK
MEMORY
INT
VIDEO
12345678
FOREGROUND
BLACK
MEMORY
INT
VIDEO
12345678
PATTERN/KEY PAD
2
1
To Next Page
Loading...
Need help?
General
