Maintenanceandprecautions
See page 14 for the details of discs
which you can use with your
camcorder.
Notes on use
• Hold tile disc by its edge while supporting
the center hole lightly. Do not touch tile
recording side (the opposite uf the primed
side when using a single-sided disc).
• Before shooting, be sure to remove dust
and fingerprints from tile disc with a soft
cloth. Otherwise you may not be able to
record or play normalb, in some situations
using that disc.
• When you set tile disc in your camcorder.
press firmly until it clicks. When tile
message [C:I3:r-IN] appears on the LCD
screen, open the disc cover and set tile
disc again.
• Do not attach any adhesive material such
as a sticker on the surface of a disc. If you
do so. the disc may become unbalanced.
and this may cause a malfunction of tile
disc or your camcorder.
Useofdouble-sideddiscs
Double-sided discs allow you to record
both sides of a disc.
N Recording on the Aside
Place the disc in your camcorder with tileside
with the _ symbol at tile center facing
outwards until it clicks.
__ symbol
Place the _ symbol lhcing
outwards.
Recording ismade on the rcar side.
• When using a double-sided disc. take care
not to smudge tile surface with
fingerprints.
• When a double-sided disc is used in your
camcorder, recording/playback are
perlk_rmed on that side only. You cannot
switch to record on or play back the other
skle with the disc set to the camcorder.
When recording/playback of one side is
complete, remove tile disc and turn it uver
to access the other side.
• Perform tile following uper:diuns on each
side of a double-sided disc:
Finalizing (p. 44)
Unfinalizing (p. 60)
Formatting (p. 59)
100
To Next Page
Loading...
Need help?
General