Step2: Chargingthe batterypack
Battery
AC Adaptor
l
Jack cover-
DC
POWER switch
4
IC IN jack
I jt_ CHGI (charge)
_lamp
Power cord
To the wall outlet
You can charge the "InfoLITHIUM"
battery pack (H series) (p. 103) after
attaching it to your camcorder.
Notes
• You can use only "[n/oLITHIUM" battery pack
H series.
4
Connect the power cord to the AC
Adaptor and the wail outlet.
Tile CH(-; (charge) lmnp lights up and
charging starts. The CHG (charge) lamp
turns off when tile battery is fully
charged.
4
/ Turn the POWER switch in the
direction of the arrow to OFF
(CHG) (The default setting).
5
Disconnect the AC Adaptor from
the DC IN jack on your
camcorder.
rt
Attach the battery pack by sliding
it in the direction of the arrow
until it clicks.
3 Connect the AC Adaptor to the
DC IN jack of your camcorder.
Open tile jack cmer, and connect tile
DC plug of the AC Adaptor.
Match tile • mark on tile DC plug with
tile • mark on your camcorder.
Notes
• Disconnecl tile AC Adaptor trom the DC IN
jack holding both the camcorder mM the DC
plug.
To remove the battery pack
Turn tile POWER switch to OFF(CH(;).
Slide the BATT (battery) release lever and
remove the battery pack.
22
To Next Page
Loading...
Need help?
General